2025-03-12

SECOND ROW RECLINER MOTOR - LEFT HAND - 60P (Remove and Replace)

Correction code 1305031102 FRT 0.40 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Remove LH seat assembly from vehicle. See 2ND ROW SEAT 5 SEATER - 60 (Remove and Replace).
  2. Remove LH seat back assembly from seat rail. See Seat Back - 2nd Row - LH (Remove and Replace).
  3. Remove bolt securing recliner motor to LH seat back frame
    s
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Ratchet/torque wrench
    • Torx T30 socket
  4. Move motor inward along LH seat recliner shaft direction.
    Informational PurposesAn informational icon, calling your attention
    Note
    Ensure sufficient space to see omega ring.
  5. Remove omega ring from LH seat recliner shaft.
    Informational PurposesAn informational icon, calling your attention
    Note
    Discard after removal.
  6. Remove the recliner tube from seat back frame.
  7. Remove recliner motor from LH seat recliner tube.

Install

  1. Install recliner motor to 60 seat recliner tube.
  2. Install recliner tube into 60 seat back frame.
  3. Install omega ring to 60 recliner shaft.
    Informational PurposesAn informational icon, calling your attention
    Note
    Install new omega ring, and confirm that the card is inserted into the slot.
  4. Install bolt securing recliner motor to 60 seat back frame.
    5 Nm (3.7 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Ratchet/torque wrench
    • Torx T30 socket
  5. Install LH seat back assembly to seat rail. See Seat Back - 2nd Row - LH (Remove and Replace).
  6. Install LH seat assembly to vehicle. See 2ND ROW SEAT 5 SEATER - 60 (Remove and Replace).
  7. Connect a laptop with Toolbox 3 to the vehicle. See Toolbox 3 (Connect and Disconnect).
  8. In Toolbox, click on the Actions tab, and then search for "Recline".
  9. Click PROC_VCLEFT_X_2R-SEAT-RECLINE-CALIBRATION, click Run, and allow the routine to complete.
  10. Disconnect Toolbox and remove the laptop from the vehicle.
  11. Exit Service Mode Plus. SeeService Mode Plus.
  12. Raise all windows and close all four doors.