Quad Camera Cover Lower - AP4 (Remove and Replace)
Correction code
1505010102
FRT
0.05
NOTE: Unless
otherwise explicitly stated in the procedure, the above correction code and
FRT reflect all of the work required to perform this procedure, including
the linked procedures. Do
not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are
created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make
sure wearing proper PPE when performing the below procedure.
Remove
- Open the LH front door and lower the LH front window.
-
Squeeze on the both sides of the lower
camera cover and pull it downward away from the rear view mirror to release the tabs
(x4).
-
Depress the tabs (x2) to
remove the tether from the lower camera cover, and then remove the lower
quad camera cover.
Install
-
Guide the hook of the tether through
the anchor on the lower camera cover to install the tether.
-
Pinch the upper portion of the lower
camera cover and engage the cover into the locking tabs (x4).
- Raise the LH front window and close the LH front door.