WHEELHOUSE INSULATOR - REAR - LEFT HAND (Remove and Replace)
Correction code
1530010702
FRT
0.25
NOTE: Unless
otherwise explicitly stated in the procedure, the above correction code and
FRT reflect all of the work required to perform this procedure, including
the linked procedures. Do
not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are
created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make
sure wearing proper PPE when performing the below procedure.
Remove
- Remove the LH quarter cavity NVH stuffer. See QUARTER CAVITY STUFFER NVH (Remove and Replace).
- Cut the LH rear wheelhouse insulator near the LH body harness to allow the harness to be routed out of the insulator's opening hole.
- Remove the LH rear wheelhouse insulator from the vehicle.
Install
- Cut the LH rear wheelhouse insulator near the LH body harness to allow the harness to be routed into the insulator's opening hole.
- Install the LH rear wheelhouse insulator to the vehicle.
- Install the LH quarter cavity NVH stuffer. See QUARTER CAVITY STUFFER NVH (Remove and Replace).