2026-08-25

Instrument Panel - Defrost Cover - LH (Remove and Replace)

Correction code 1405020902 FRT 1.68 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

  • 2026-08-25: Removed steps to remove and install the float wing assembly.

Torque Specifications

Table 1. Torque Specifications: Instrument Panel - Defrost Cover - LH (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Screws (x2) that attach the LH defrost duct to the instrument panel upper assembly
0.9 Nm (8 lbs-in)
  • Torx T20 bit
  • Digital Torque Screwdriver 0.10Nm - 2.0Nm
 Reuse

Remove

  1. With assistance, release the tabs and remove the instrument panel upper carrier assembly from the vehicle. See Assembly - Instrument Panel - Upper (Remove and Replace).
    Note
    Do not separate the components from the upper carrier assembly. Just remove the assembly from the vehicle.
  2. Remove the screws (x2) that attach the LH defrost duct to the instrument panel upper assembly, and then remove the duct from the assembly.
    Tip
    Use of the following tool(s) is recommended:
    • Torx T20 bit
    • Digital Torque Screwdriver 0.10Nm - 2.0Nm

Install

  1. Install the screws (x2) that attach the LH defrost duct to the instrument panel upper assembly.
    0.9 Nm (8 lbs-in)
    Tip
    Use of the following tool(s) is recommended:
    • Torx T20 bit
    • Digital Torque Screwdriver 0.10Nm - 2.0Nm
  2. Install the instrument panel upper carrier to the vehicle. See Assembly - Instrument Panel - Upper (Remove and Replace).