2025-01-23

Shield - Body Controller - Front (Remove and Replace)

Correction code TBD FRT 0.15 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Table 1. Torque Specifications: Shield - Body Controller - Front (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolts (x2) that attach the front body controller module shield to the front body controller module
8.5 Nm (6.3 lbs-ft)
  • 10 mm socket
Reuse

Remove

  1. Disconnect the LV battery. See LV Power (Disconnect and Connect).
  2. Remove the cabin intake duct. See Duct - Air Intake (Remove and Replace).
  3. Release the clip that attaches the supermanifold harness to the front body controller module.
  4. Disconnect the thermal harness from the front body controller module connector.
  5. Remove the bolts (x2) that attach the front body controller module shield to the front body controller module, and then remove the shield.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm socket

Install

  1. Install the front body controller module shield, and then install the bolts (x2) that attach the front body controller module shield to the front body controller module.
    8.5 Nm (6.3 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm socket
  2. Connect the thermal harness to the front body controller module connector.
  3. Install the clip that attaches the supermanifold harness to the front body controller module.
  4. Connect the LV battery. See LV Power (Disconnect and Connect).
  5. Install the cabin intake duct. See Duct - Air Intake (Remove and Replace).