HV Battery System - HV Battery Assembly - Ancillary Bay Engagement Seal
Correction code
NEW
FRT 2.75
NOTE: Unless
otherwise explicitly stated in the procedure, the above correction code and
FRT reflect all of the work required to perform this procedure, including
the linked procedures. Do
not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are
created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make
sure wearing proper PPE when performing the below procedure.
Remove
- Remove the HV battery. See HIGH VOLTAGE BATTERY - REAR WHEEL DRIVE - 3 PHASE (Remove and Install).
- Remove and discard the ancillary bay engagement seal.
Install
- Install a new ancillary bay engagement seal onto the HV battery pack.
- Install the HV battery. See HIGH VOLTAGE BATTERY - REAR WHEEL DRIVE - 3 PHASE (Remove and Install).