2025-01-05

Speaker - Full Range - 60MM - LH (Remove and Replace)

Correction code 2121010302 FRT 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Torque Specifications

Table 1. Torque Specifications: Speaker - Full Range - 60MM - LH (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Screws (x3) that attach the 60mm full range speaker to the headliner
0.4 Nm (4 lbs-in)
  • Torx T10 bit
  • Digital Torque Screwdriver 0.10Nm - 2.0Nm
 Reuse

Remove

  1. Remove the LH upper A-pillar trim. See Trim - A-Pillar - Upper - LH (Remove and Replace).
  2. Remove the LH sun visor. See Sun Visor - LH (Remove and Replace).
  3. Release the high retention clip at the LH front headliner area, and then pull down the LH front headliner and use an inflatable air bag to support the headliner.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Pliers Needle nose long bent
  4. Remove the screws (x3) that attach the 60mm full range speaker to the headliner, and then disconnect the electrical connector.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T10 bit
    • Digital Torque Screwdriver 0.10Nm - 2.0Nm

Install

  1. Connect the electrical connector, and then install the screws (x3) that attach the 60mm full range speaker to the headliner.
    0.4 Nm (4 lbs-in)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T10 bit
    • Digital Torque Screwdriver 0.10Nm - 2.0Nm
  2. Restore the LH front headliner area.
  3. Install the LH sun visor. See Sun Visor - LH (Remove and Replace).
  4. Install the LH upper A-pillar trim. See Trim - A-Pillar - Upper - LH (Remove and Replace).