2025-03-12
Breather - 3DU (Remove and Replace)
Correction code
3901020102
FRT
0.10
NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.
Description | Torque Value | Recommended Tools | Reuse/Replace | Notes |
---|---|---|---|---|
Front drive unit breather |
![]() 5 Nm (3.7 lbs-ft) |
|
Replace |
Remove
- Remove the HEPA filter assembly. See HEPA Filter Assembly (Remove and Replace).
-
Move the front harness bracket forward appropriately to remove the front
drive unit breather.
TIpUse of the following tool(s) is recommended:
- Ratchet/torque wrench
- ¼ in to 3/8 in adapter
- 22 mm socket
- 3 in extension
Install
-
Install the new front drive unit
breather.5 Nm (3.7 lbs-ft)TIpUse of the following tool(s) is recommended:
- Ratchet/torque wrench
- ¼ in to 3/8 in adapter
- 22 mm socket
- 3 in extension
- Install the HEPA filter assembly. See HEPA Filter Assembly (Remove and Replace).