2025-03-12

Wiper Module (RHD) (Remove & Replace)

Correction code 1750020102 FRT 0.25 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Remove the cowl screen panel. See Cowl Screen (Remove and Replace).
  2. Remove the bolts (x2) that attach the wiper module to the body.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm socket
  3. Carefully pull the wiper module towards the front of the vehicle to release the rubber anchor from the bracket on the bulkhead.
  4. Disconnect the electrical connector from the wiper module, and then remove the wiper module from the vehicle.

Install

  1. Carefully move the wiper module towards the rear of the vehicle, to align the rubber anchor with the bracket on the bulkhead.
  2. Connect the electrical connector to the wiper module.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Check the harness to make sure it is routed correctly.
  3. Install the bolts (x2) that attach the wiper module to the body.
    9 Nm (6.6 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm socket
  4. Install the cowl screen panel. See Cowl Screen (Remove and Replace).
  5. Enable Service Mode through the touchscreen. See Service Mode.
  6. Unlock Gateway. See Gateway (Unlock).
  7. Run the Wiper Replacement procedure: on the touch screen, touch Closures > Closures > Windows > Wiper Module replacement, touch Run, and allow the routine to complete.
  8. Perform a software reinstall. See Software Reinstall - Touchscreen.
  9. Exit Service Mode through the touchscreen. See Service Mode.
  10. Raise LH front window and close LH front door.