2026-01-29

Motor - Recliner - 3rd Row (Model YL) (Remove and Install)

Correction code 13030100001 FRT 1.56 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Remove

  1. Remove the recliner shaft from the seat back frame. See Shaft - Recliner - 3rd Row (Model YL) (Remove and Replace).
  2. Remove the bolt that attaches the recliner motor to the seat back frame, and then release the location tab and remove the motor.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T30 socket

Install

  1. Position the recliner motor to the seat back frame and secure the location tab, and then install the bolt that attaches the motor to the frame.
    5 Nm (3.7 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T30 socket
  2. Install the recliner shaft from the seat back frame. See Shaft - Recliner - 3rd Row (Model YL) (Remove and Replace).