2025-03-12
1st Row Heat Pad Seat Backrest (Remove and Replace)
Correction code
1307011702
FRT
0.80
NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.
Warning
Seat base edges are
sharp and can cause personal injury. Wear cut resistant gloves when removing the seat
from the vehicle, and while performing procedures that involve work on or near the seat
base.
Note
Seat back heat pad replacement requires
replacing the foam (1744935-00-A). Please order the seat back foam together with the heat
pad.
Remove
- Remove the driver seat back trim from the foam. See Soft Trim Cover - Seat Back - 1st Row - LH (Remove and Replace).
-
Remove the heat pad together with the foam pad.
Install
-
Install a new seat back heat pad onto
a new seat back foam pad.
- Install the driver seat back trim onto the foam assembly, and then install the foam assembly to the vehicle. See Soft Trim Cover - Seat Back - 1st Row - LH (Remove and Replace).