2026-08-09

Armrest - Outer - Center Console (Remove and Replace)

Correction code 1519010192 FRT 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Remove

  1. Open the LH front door and lower the LH front window.
  2. Move the driver seat rearward and adjust the seatback to a lower position to ensure sufficient clearance for operation near the console rear side panel.
  3. Lift up the center console armrest.
  4. Release the clips that attach the inner armrest to the outer armrest.
    Note
    Use a trim tool and start from the top of the armrest to release the clips, then work towards the bottom.
  5. Remove the screws (x4) that attach the armrest hinge to the outer armrest, then remove the outer armrest from the vehicle.
    Tip
    Use of the following tool(s) is recommended:
    • Torx T20 bit

Install

  1. Position the outer armrest to the center console, and then install the screws (x4) that attach the armrest hinge to the outer armrest.
    1.2 Nm (.9 lbs-ft)
    Tip
    Use of the following tool(s) is recommended:
    • Torx T20 bit
  2. Align the locator pins, and then engage the clips that attach the inner armrest to the outer armrest.
  3. Close the center console armrest.
  4. Move the driver seat back to its original position.
  5. Raise the LH front window and close the LH front door.