Hoses - Battery Return Tube (Remove and Replace)
Correction code
1830021702
FRT
3.24
NOTE: Unless
otherwise explicitly stated in the procedure, the above correction code and
FRT reflect all of the work required to perform this procedure, including
the linked procedures. Do
not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are
created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See Personal Protection to make
sure wearing proper PPE when performing the below procedure.NOTE:
See Ergonomic Precautionsfor safe
and healthy working practices.
Remove
- Remove penthouse engagement seal from HV battery pack. See Ancillary Bay Engagement Seal.
-
Disconnect RH coolant hose from rear
of HV battery.
-
Release clips securing HV battery return tube from rear of HV battery.
-
Release HV battery return tube from LH side of HV battery and allow hose to fully
drain.
Install
-
Install HV battery return tube onto LH
side of HV battery.
-
Install clips securing HV battery return tube to rear of HV battery.
-
Connect RH coolant hose to rear of HV battery.
- Install penthouse engagement seal to HV battery pack. See Ancillary Bay Engagement Seal.