Frame - Back Rest - Driver (Model YL) (Remove and Replace)
Correction code
13010200202
FRT
1.26
NOTE: Unless
otherwise explicitly stated in the procedure, the correction code and its
associated FRT reflect all of the work required to perform this procedure,
including the linked procedures. Do not stack correction
codes unless explicitly told to do so.
NOTE: See Flat Rate Times to
learn more about FRTs and how they are created.
NOTE: See Personal Protection to make
sure you are wearing proper PPE when performing the procedure below.
NOTE: See Ergonomic Precautions for safe and healthy
working practices.
Torque Specifications
| Description | Torque Value | Recommended Tools | Reuse/Replace | Notes |
|---|---|---|---|---|
| Inboard and outboard bolts (x4) that attach the seat back frame to the seat cushion frame |
 43 Nm (31.7 lbs-ft) |
|
Replace | 1128435-00-C |
Remove
-
Remove the driver seat back frame. See Frame - Back Rest - Driver (Model YL) (Remove and Install).
NoteDuring removal, certain steps require extra care. See the animation(s) for detailed guidance.
Install
- Install the driver seat back frame. See Frame - Back Rest - Driver (Model YL) (Remove and Install).
- Place the vehicle in Service Mode by using the touchscreen. See Service Mode.
- Unlock the vehicle gateway. See Gateway (Unlock).
- Perform the following routine using Service Mode or Toolbox (see 0005 - Service Modes): PROC_VCLEFT_SEAT-CALIBRATEvia Service Mode:Low Voltage ➜ Seats ➜ Calibrate Seatvia Toolbox:(link)
- Exit Service Mode. See Service Mode.