Bushing- RHD - 3DU (Remove and Replace)
Correction code
4001020202
FRT
3.42
NOTE: Unless
otherwise explicitly stated in the procedure, the correction code and its
associated FRT reflect all of the work required to perform this procedure,
including the linked procedures. Do not stack correction
codes unless explicitly told to do so.
NOTE: See Flat Rate Times to
learn more about FRTs and how they are created.
NOTE: See Personal Protection to make
sure you are wearing proper PPE when performing the procedure below.
NOTE: See Ergonomic Precautions for safe and healthy
working practices.
- 2026-07-09: Updated the steps to maneuver the halfshafts for drive unit installation/removal; adjusted the step sequence of torquing the rear damper mounting bolt; added two alternative methods for setting the rear suspension to ride height.
Remove
- Remove the rear drive unit. See Rear Drive Unit - 3DU - High Current (Remove and Replace)
-
Position the rear drive unit above an
empty rear drive unit crate.
NoteUse a pallet if no crate is available.
-
Install the bushing removal tool on
the RH bushing.
-
Press bushing out from casting.
-
When the bushing has been pushed out
of the drive unit, separate the bushing removal tool, and then remove it from the drive
unit.
Replace
-
Set up the bushing tool to press in
the new bushing.
-
Press in RH bushing.
-
Separate the bushing tool and remove
from drive unit.
- Install the rear drive unit. See Rear Drive Unit - 3DU - High Current (Remove and Replace)