2024-11-11

Rear Suspension Cover - LH (Remove and Replace)

Correction code TBD FRT 0.1 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: Rear Suspension Cover - LH (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolt that attaches the rear suspension cover to the LH lower rear control arm assembly
5 Nm (3.7 lbs-ft)
  • 10 mm socket
Reuse

Remove

  1. Raise and support the vehicle. See Raise Vehicle - 2 Stands.
  2. Remove the bolt that attaches the rear suspension cover to the LH lower rear control arm assembly.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm socket
  3. Release the tabs (x2) that attach the rear suspension cover to the LH lower rear control arm assembly, and then remove the LH rear suspension cover from the vehicle.

Install

  1. Install the bolt and tabs (x2) that attach the rear suspension cover to the LH lower rear control arm assembly.
    5 Nm (3.7 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm socket
  2. Remove the vehicle from the lift. See Raise Vehicle - 2 Stands.