SINGLE AXIS 480G- CONN AXIS - TYPE 4 IMPACT SENSOR UFS6E (Remove and Replace)
Correction code
2020010502
FRT
0.65
NOTE: Unless
otherwise explicitly stated in the procedure, the above correction code and
FRT reflect all of the work required to perform this procedure, including
the linked procedures. Do
not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are
created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make
sure wearing proper PPE when performing the below procedure.
Torque Specifications
Description | Torque Value | Recommended Tools | Reuse/Replace | Notes |
---|---|---|---|---|
Bolt that attaches the LH accelerometer sensor to the front bumper beam |
![]() 10 Nm (7.4 lbs-ft) |
|
Reuse |
Remove
- Disconnect LV battery. See LV Power (Disconnect and Connect).
- Remove the front fascia assembly. See FRONT FASCIA (Remove and Install).
- Disconnect the LH accelerometer sensor connector.
-
Remove the bolt that attaches the LH accelerometer sensor to the front bumper beam,
and then move the sensor from the vehicle.
TIpUse of the following tool(s) is recommended:
- 10 mm socket
Install
-
Install the bolt that attaches the LH
accelerometer sensor to the front bumper beam.10 Nm (7.4 lbs-ft)TIpUse of the following tool(s) is recommended:
- 10 mm socket
- Connect the LH accelerometer sensor connector.
- Install the front fascia assembly. See FRONT FASCIA (Remove and Replace).
- Connect LV battery. See LV Power (Disconnect and Connect).