2025-03-12

INSTRUMENT PANEL RISER - LEFT HAND (Remove and Replace)

Correction code 1405020602 FRT 0.10 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: INSTRUMENT PANEL RISER - LEFT HAND (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
10mm bolt that secures the LH instrument panel riser bracket
6 Nm (4.4 lbs-ft)
  • 10 mm deep socket
Reuse
13mm bolt and nut that secure the LH instrument panel riser bracket
25 Nm (18.4 lbs-ft)
  • 13 mm socket
Reuse

Remove

  1. Remove the LH center console front side panel. See CONSOLE SIDE PANEL LEFT HAND (Remove and Replace).
  2. Remove the bolts (x2) and the nut that secure the LH instrument panel riser bracket.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 3 in extension
    • Cordless Ratchet/Impact Driver
    • 10 mm deep socket/13 mm socket
    • Ratchet/torque wrench
  3. Remove the LH instrument panel riser bracket.

Install

  1. Place the LH instrument panel riser bracket into the vehicle.
  2. Install the bolts (x2) and the nut that secure the LH instrument panel riser bracket.
    6 Nm (4.4 lbs-ft)
    25 Nm (18.4 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    The 10mm bolt is 6 Nm. The 13mm nut and bolt are 25 Nm.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 3 in extension
    • Cordless Ratchet/Impact Driver
    • 10 mm deep socket/13 mm socket
    • Ratchet/torque wrench
  3. Install the LH center console front side panel. See CONSOLE SIDE PANEL LEFT HAND (Remove and Replace).