2025-03-17

License Plate - Rear (NA) (Install) (Installation)

Correction code 1207010306 FRT 0.05 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: License Plate - Rear (NA) (Install) (Installation)
Description Torque Value Recommended Tools Reuse/Replace Notes
Screws (x2) that attach the upper part of the license plate to the rear lower fascia
2 Nm (1.5 lbs-ft)
  • PH1 Stubby Phillips Screwdriver
  • PH1 Phillips Screwdriver Bit
Reuse

Procedure

  1. Position the license plate onto the rear lower fascia, and align the plate with the fascia marks.
    Informational PurposesAn informational icon, calling your attention
    Note
    The mounting bracket is not needed.
  2. Install the screws (x2) that attach the upper part of the license plate to the rear lower fascia.
    2 Nm (1.5 lbs-ft)
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Do not install the screws to the lower part of the license plate, as it will damage the fascia.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • PH1 Stubby Phillips Screwdriver
    • PH1 Phillips Screwdriver Bit