2026-07-02

Bump Stop - Hood (Remove and Replace)

Correction code 1010010202 FRT 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

This procedure assumes the hood striker, hinges, bump stops, and plugs are undamaged. Inspect these components from the old hood and if necessary, replace with new parts.
  • 2026-07-02: Released new procedure.
Table 1. Torque Specifications: Hood (Remove and Install)
Description Torque Value Recommended Tools Reuse/Replace Notes
Nuts (x4) that secure hood to LH and RH hood hinges
27 Nm (19.9 lbs-ft)
  • 13 mm socket
 Reuse

Remove

  1. Open the LH front door and lower the LH front window.
  2. Open the hood.
  3. Turn counter-clockwise to remove the LH hood bump stop from the hood.

Replace

Warning IconA warning icon, calling your attention to a possibly risky situation
CAUTION
If using this procedure to install an unpainted part, make sure to apply seam sealer to all seams prior to installing and painting the part. Refer to the Collision Repair manual for more information.
  1. Turn clockwise to install the LH hood bump stop to the hood.
  2. Close the hood.
  3. Check that hood fitment meets specifications per CVIS.
  4. Raise the LH front window and close the LH front door.