Seat Assembly - 2nd Row - LH (5-Seat) (Remove and Replace)
Correction code
1305010502
FRT
0.30
NOTE: Unless
otherwise explicitly stated in the procedure, the correction code and FRT
listed above reflect all of the work required to perform this procedure,
including the linked procedures. Do not stack correction
codes unless explicitly told to do so.
NOTE: See Flat Rate Times
to learn more about FRTs and how they are created.
NOTE: See Personal Protection
to make sure you are wearing proper PPE when performing the procedure
below.
NOTE:
See Ergonomic Precautions for
safe and healthy working practices.
Torque Specifications
| Description | Torque Value | Recommended Tools | Reuse/Replace | Notes |
|---|---|---|---|---|
| Bolts that attach the 2nd row 60/40 seat frame to body |
 37 Nm (27.3 lbs-ft) |
|
Replace | 1616775-00-B |
Remove
- Remove the 2nd row LH seat assembly from the vehicle. See Seat Assembly - 2nd Row - LH (5-Seat) (Remove and Install).
Install
- Install the 2nd row LH seat assembly onto the vehicle. See Seat Assembly - 2nd Row - LH (5-Seat) (Remove and Install).
- Connect a laptop to the diagnostic port of the vehicle, and then use Toolbox 3 to locally connect to the vehicle. See Toolbox (Connect and Disconnect).
- In Toolbox, click the Actions tab, type "Recline" into the search field, click PROC_VCLEFT_X_2R-SEAT-RECLINE-CALIBRATIONvia Service Mode:Low Voltage ➜ Second Row Seats ➜ Calibratevia Toolbox:(link), click Run, and allow the routine to complete.
- Exit Service Mode Plus and disconnect the laptop from the vehicle. See Service Mode Plus.