2026-08-09

1st Row - Seat Belt Lap Pretensioner - LH (Remove and Replace)

Correction code 2010010102 FRT 0.30 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

  • 2026-02-20: Added note on using PROC_RCM_DISARM if using this procedure to diagnose the SRS.
  • 2026-02-13: Added steps to disconnect/connect the LV power.
Warning
If using this procedure to diagnosis the vehicle's Supplemental Restraint Systems (SRS), disarm the RCM, which will prevent all airbags and pretensioners from deploying. Re-arm the RCM after all of the vehicle's SRS components are re-installed.
  • Disarm RCM:PROC_RCM_DISARMvia Service Mode Plus:
    • Safety & Restraints ➜ Airbags ➜ Disarm RCM
    • Safety & Restraints ➜ Seats ➜ Disarm RCM
    via Toolbox:(link)
  • Re-arm RCM:PROC_RCM_ARMvia Service Mode Plus:
    • Safety & Restraints ➜ Airbags ➜ Re-Arm RCM
    • Safety & Restraints ➜ Seats ➜ Re-Arm RCM
    via Toolbox:(link)

Remove

  1. Remove the driver seat outboard sideshield. See Side Shield - Outboard - Driver Seat (Remove and Replace).
    Note
    No need to remove the 8 way and lumbar switch assembly from the outboard sideshield.
  2. Disconnect the LV power. See LV Power (Disconnect and Connect) (Modify).
  3. Disconnect the electrical connector from the pretensioner.
  4. Remove and discard the bolt that attaches the lap pretensioner to the seat track.
    Tip
    Use of the following tool(s) is recommended:
    • Torx T50 socket
  5. Remove the lap pretensioner from the seat track.