2025-03-12

Window Regulator (Recalibrate) (Module Reset/Reflashed)

Correction code 11500010 FRT 0.05 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Procedure

  1. Get into the driver seat, and then close the door.
  2. Place the vehicle in Service Mode by using the touchscreen. See Service Mode.
  3. Unlock the vehicle gateway. See Gateway (Unlock).
  4. On the touchscreen, touch Controls > Service Mode > Closures > Windows, and then tap each window's Calibrate button to calibrate the windows.
    Informational PurposesAn informational icon, calling your attention
    Note
    During window calibration, the selected window(s) will roll up and down until window calibration is complete.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Pinch detection is disabled during window calibration.
  5. Exit Service Mode. See Service Mode.