2024-11-11

Cabin Temperature Sensor - Fan Driven (Remove and Replace)

Correction code 1810010102 FRT 0.05 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Open the LH front door, and lower the LH front window.
  2. Use a plastic trim tool to release the clips (x4) and guide pins (x2) that attach the service panel to the instrument panel.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    An electrical harness is still connected to the service panel. Do not pull the service panel too far from the instrument panel.
  3. Disconnect the electrical harness from the cabin temperature sensor.
  4. Remove the service panel from the touchscreen.
  5. Remove the bolts (x2) that attach the cabin temperature sensor to the service panel, and then separate the sensor from the service panel.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 bit

Install

  1. Position the cabin temperature sensor to the instrument panel service panel, and then install the bolts (x2) that attach the sensor to the service panel.
    0.7 Nm (6 lbs-in)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 bit
  2. Connect the temperature sensor connector, and then secure the clips (x2) and tabs (x4) that attach the service panel to the vehicle.
  3. Raise the LH front window and close the LH front door.