2025-03-18

Fan - Camera - Forward Facing (Remove and Replace)

Correction code 1020022102 FRT 0.20 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

  1. 2025-03-18: Added steps to disconnect and connect the LV power to prevent part damage.

Torque Specifications

Table 1. Torque Specifications: Fan - Camera - Forward Facing (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Screws (x3) that secure the forward facing camera fan
0.12 Nm (1 lbs-in)
  • SET, 1/2" CUT BIT. (78 PCS DOUBLE END MINI RATCHET)
  • T6 TORX BIT 1/4 IN HEX SHANK
  • Digital Torque Screwdriver 0.10Nm - 2.0Nm
Reuse

Remove

  1. Disconnect the LV battery power. See LV Power (Disconnect and Connect).
  2. Remove the upper camera cover assembly. See QUAD CAM CVR UPR (Remove and Replace).
    Informational PurposesAn informational icon, calling your attention
    Note
    It is not necessary to remove the interior camera from the upper camera cover.
  3. Remove the screws (x3) that secure the forward facing camera fan.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • SET, 1/2" CUT BIT. (78 PCS DOUBLE END MINI RATCHET)
    • T6 TORX BIT 1/4 IN HEX SHANK
    • Digital Torque Screwdriver 0.10Nm - 2.0Nm
  4. Remove the forward facing camera fan.

Install

  1. Install the forward facing camera fan onto the windshield.
  2. Install the screws (x3) that secure the forward facing camera fan.
    0.12 Nm (1 lbs-in)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • SET, 1/2" CUT BIT. (78 PCS DOUBLE END MINI RATCHET)
    • T6 TORX BIT 1/4 IN HEX SHANK
    • Digital Torque Screwdriver 0.10Nm - 2.0Nm
  3. Install the quad camera upper cover assembly. See QUAD CAM CVR UPR (Remove and Replace).
  4. Connect the LV battery power. See LV Power (Disconnect and Connect).