2025-03-12

TIE ROD OUTER - LEFT HAND (Remove and Replace)

Correction code 3201010402 FRT 0.20 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: TIE ROD OUTER - LEFT HAND (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Jamb nut at the LH tie rod outer assembly
80 Nm (59.0 lbs-ft)
  • 21 mm 12pt combination wrench
Reuse
Nut that attach the LH tie rod outer assembly to LH front knuckle
180 Nm (132.7 lbs-ft)
  • 22 mm deep socket
Replace 1109263-00-A

Remove

  1. Inspect the vehicle for abnormal tire wear that might indicate the need for a wheel alignment, and note any findings.
  2. Remove the LH front wheel. See Wheel Assembly (Remove and Install).
  3. Use a paint pen to apply a witness mark to the tie rod and jamb nut so that the two can be realigned later on during the LH tie rod end installation.
  4. Loosen the jamb nut at the LH tie rod end.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 21 mm 12pt combination wrench
  5. Remove and discard the nut that attaches the LH front tie rod end to the LH front suspension knuckle.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 22 mm deep socket
  6. Remove the tie rod from the steering linkage by turning the tie rod counter-clockwise.
    Informational PurposesAn informational icon, calling your attention
    Note
    Record the number of rotations for separation of the tie rod from the steering linkage.

Install

  1. Rotate the tie rod outer assembly to install the LH tie rod outer assembly.
  2. Position LH tie rod outer assembly to LH front knuckle.
  3. Align tie rod outer assembly to original location marked on threads.
  4. Install a new nut that attaches the LH front tie rod end to the LH front suspension knuckle.
    180 Nm (132.7 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 22 mm deep socket
  5. Torque jamb nut to tie rod outer assembly.
    80 Nm (59.0 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 21 mm 12pt combination wrench
  6. Install the front wheels. See Wheel Assembly (Remove and Install).
  7. Refer to the Alignment Requirement tables to determine whether an EPAS alignment check (EC) or four wheel alignment check (AC) is necessary. If performed, add the alignment check/adjust as a separate activity. See Alignment Requirement - Suspension.