2026-08-09

1st Row Track Cover - LH (Remove and Replace)

Correction code 1301021402 FRT 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Remove

  1. Open the LH doors and lower the LH windows.
  2. Move the driver seat fully forward.
  3. Remove and discard the bolts (x2) that attach the rear of the driver seat to body.
    Tip
    Use of the following tool(s) is recommended:
    • Cordless Ratchet/Impact Driver
    • Torx Plus TP45 Bit Socket
    • Ratchet/torque wrench
  4. Move the driver seat fully rearward.
  5. Remove and discard the bolts (x2) that attach the front of the driver seat to body.
    Tip
    Use of the following tool(s) is recommended:
    • Cordless Ratchet/Impact Driver
    • Torx Plus TP45 Bit Socket
    • Ratchet/torque wrench
  6. Lift the driver seat upward, and then slide the track covers forward to remove it from the seat assembly.

Install

  1. Lift the driver seat upward, and then install the seat track covers to the vehicle.
  2. Move the driver seat fully rearward.
  3. Install new bolts (x2) to attach the front of the driver seat to body.
    33.5 Nm (24.7 lbs-ft)
    Tip
    Use of the following tool(s) is recommended:
    • Cordless Ratchet/Impact Driver
    • Torx Plus TP45 Bit Socket
    • Ratchet/torque wrench
  4. Move the driver seat fully forward.
  5. Install new bolts (x2) to attach the rear of the driver seat to body.
    33.5 Nm (24.7 lbs-ft)
    Tip
    Use of the following tool(s) is recommended:
    • Cordless Ratchet/Impact Driver
    • Torx Plus TP45 Bit Socket
    • Ratchet/torque wrench
  6. Move the driver seat to its original position.
  7. Raise the LH windows and close the LH doors.