SECOND ROW SEAT BACK SOFT TRIM COVER - RIGHT HAND (Remove and Replace)
Correction code
1308012102
FRT
0.00
NOTE: Unless
otherwise explicitly stated in the procedure, the above correction code and
FRT reflect all of the work required to perform this procedure, including
the linked procedures. Do
not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are
created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make
sure wearing proper PPE when performing the below procedure.
- 1501599-00-A, Pliers, Hog Ring
Remove
- Remove the seat back shell from foam trim assembly. See Shell - Seat Back - 2nd Row - RH (Remove and Replace).
-
Gently separate the LH 2nd
row seat back upholstery cover from the foam starting from the bottom of the
cover.
NoteMake sure the Velcro does not damage the foam pad.
-
Use diagonal cutters to cut the hog rings (x3) at the center of the seat
back, and then release the cover from the hog rings.
NotePush down on the foam to gain access to the rings.NoteRemove any excess hog ring pieces.
-
Gently release the remaining
Velcro that attach the LH 2nd row seat back upholstery cover to the foam
pad.
NoteMake sure the Velcro does not damage the foam pad.
- Feed the seat belt through the upholstery cover, and then remove the cover from the foam pad.
Install
-
Starting from the upper seat
back, feed the seat belt through the upholstery cover, and then install the
LH 2nd row seat back upholstery cover.
NoteMassage the Velcro while working downward toward the center of the seat back.
-
Use hog ring pliers to
crimp new hog rings (1566544-00-A x3) to the LH 2nd row seat back upholstery
cover at the center of the seat back.
NotePlace the hog ring into the hog ring pliers prior to installation.NotePush down on the foam to gain access to the rings.
- Install the seat back shell from foam trim assembly. See Shell - Seat Back - 2nd Row - RH (Remove and Replace).