SUN VISOR - LEFT HAND (Remove and Replace)
Correction code
1505020102
FRT
0.05
NOTE: Unless
otherwise explicitly stated in the procedure, the above correction code and
FRT reflect all of the work required to perform this procedure, including
the linked procedures. Do
not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are
created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make
sure wearing proper PPE when performing the below procedure.
Torque Specifications
Description | Torque Value | Recommended Tools | Reuse/Replace | Notes |
---|---|---|---|---|
Screw that attaches the sun visor to the vehicle |
![]() 3.5 Nm (2.6 lbs-ft) |
|
Reuse |
Remove
- Open the LH front door and lower the LH front window.
-
Release the clips (x4) that attach the
sun visor bracket cover to the vehicle.
NoteExtending the sun visor as needed.
-
Remove the screw that attaches the sun
visor to the vehicle.
TIpUse of the following tool(s) is recommended:
- Ratchet/torque wrench
- Torx T25 bit
- 4 in extension
- Remove the LH sun visor from the left side from the headliner area.
- Disconnect the electrical connector from the sun visor.
- Remove the sun visor from the vehicle.
Install
- Connect the electrical connector to the sun visor.
-
Install the screw that attaches the
sun visor to the vehicle.3.5 Nm (2.6 lbs-ft)TIpUse of the following tool(s) is recommended:
- Ratchet/torque wrench
- Torx T25 bit
- 4 in extension
- Install the clips (x4) that attach the sun visor bracket cover to the vehicle.
- Raise the LH front window and close the LH front door.