Harness - Liftgate Trim (Remove and Replace)
Correction code
1710030702
FRT
0.10
NOTE: Unless
otherwise explicitly stated in the procedure, the above correction code and
FRT reflect all of the work required to perform this procedure, including
the linked procedures. Do
not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are
created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See Personal Protection to make
sure wearing proper PPE when performing the below procedure.NOTE:
See Ergonomic Precautionsfor safe
and healthy working practices.
Remove
- Remove the liftegate lower trim. See Liftgate Lower Trim (Remove and Replace).
-
Disconnect the liftgate switch
connector.
-
Disconnect the liftgate lamp
connector.
-
Release the clip and hooks (x2) that
attach the liftgate harness to the liftgate lower trim, and then remove the harness from
the vehicle.
Install
-
install the clip and hooks (x2) that
attach the liftgate harness to the liftgate lower trim.
-
Connect the liftgate lamp
connector.
-
Connect the liftgate switch
connector.
- Install the liftegate lower trim. See Liftgate Lower Trim (Remove and Replace).