2025-03-12

CONSOLE LAMP SWITCH (Remove and Replace)

Correction code 1519010302 FRT 0.00 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: CONSOLE LAMP SWITCH (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Screw that attaches the rear lamp switch to the center console
1.2 Nm (.9 lbs-ft)
  • SET, 1/2" CUT BIT. (78 PCS DOUBLE END MINI RATCHET)
  • Digital Torque Screwdriver 0.10Nm - 2.0Nm
Reuse

Remove

  1. Remove the center console rear end module. See .
  2. Remove the screw that attaches the rear lamp switch to the center console.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • SET, 1/2" CUT BIT. (78 PCS DOUBLE END MINI RATCHET)
    • Digital Torque Screwdriver 0.10Nm - 2.0Nm
  3. Disconnect the console lamp switch connector, and release the connector clip, and then remove the switch from the center console.

Install

  1. Engage the console lamp switch connector clip and connect the connector.
  2. Install the screw that attaches the rear lamp switch to the center console.
    1.2 Nm (.9 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • SET, 1/2" CUT BIT. (78 PCS DOUBLE END MINI RATCHET)
    • Digital Torque Screwdriver 0.10Nm - 2.0Nm
  3. Install the center console rear end module. See .