2025-03-12

REAR BUMPER BEAM (Remove and Replace)

Correction code 1001060102 FRT 0.40 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: REAR BUMPER BEAM (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Nuts (x6) that attach the rear bumper beam or trailer hitch to the vehicle
60 Nm (44.2 lbs-ft)
  • 6 in extension
  • Ratchet/torque wrench
  • Cordless Ratchet/Impact Driver
  • 15 mm deep socket
  • Torque wrench with angle measurement (for installation only)
Reuse

Remove

  1. Remove the rear fascia and diffuser assembly. See GUID-FF55B6F8-E257-4E77-B06D-3511D38E1426.html.
  2. Remove the nuts (x6) that attach the rear bumper beam to the vehicle.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 6 in extension
    • Ratchet/torque wrench
    • Cordless Ratchet/Impact Driver
    • 15 mm deep socket
    • Torque wrench with angle measurement (for installation only)
    Figure 1. LH shown, RH similar
  3. With assistance, remove the rear bumper beam.

Install

  1. Position the rear bumper beam on the body, and then install the nuts (x6) that attach the rear bumper beam to the vehicle.
    60 Nm (44.2 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 6 in extension
    • Ratchet/torque wrench
    • Cordless Ratchet/Impact Driver
    • 15 mm deep socket
    • Torque wrench with angle measurement (for installation only)
    Figure 2. LH shown, RH similar
  2. Install the rear fascia and diffuser assembly. See GUID-FF55B6F8-E257-4E77-B06D-3511D38E1426.html.