2025-03-12

HIGH VOLTAGE DUMMY HEADER - 4P (Remove and Replace)

Correction code 1630011602 FRT 0.00 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: HIGH VOLTAGE DUMMY HEADER - 4P (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolts that attach the 4P dummy header
10 Nm (7.4 lbs-ft)
  • Electrical Protective Gloves
  • External Torx E10 5-Lobe
  • 4 in extension
  • Flex head ratchet/flex head torque wrench
Reuse

Remove

  1. Remove HV battery rear skid plate enclosure. See High Voltage Battery Assembly - Skid Plate - Rear (Remove and Replace).
  2. Remove 4P dummy header.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Electrical Protective Gloves
    • External Torx E10 5-Lobe
    • 4 in extension
    • Flex head ratchet/flex head torque wrench

Install

  1. Install 4P dummy header.
    10 Nm (7.4 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Electrical Protective Gloves
    • External Torx E10 5-Lobe
    • 4 in extension
    • Flex head ratchet/flex head torque wrench
  2. Install HV battery rear skid plate enclosure. See High Voltage Battery Assembly - Skid Plate - Rear (Remove and Replace).