2026-07-29

Insulator - Back Rest - Driver - LH (Model YL) (Remove and Replace)

Correction code 13010200602 FRT 0.42 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
Seat base edges are sharp and can cause personal injury. Wear cut resistant gloves when removing the seat from the vehicle, and while performing procedures that involve work on or near the seat base.

Remove

  1. Remove the driver seat back lumbar support. See 1st Row Power Lumbar Seatback - LH (Model YL) (Remove and Install).
    Informational PurposesAn informational icon, calling your attention
    Note
    During removal, certain steps require extra care. See the animation(s) for detailed guidance.
  2. Release the tabs (x2) of the driver seat back plastic insulator, and then pull the insulator downward to remove it from the driver seat back frame.