2025-03-12

MOLDING -SHOCK TOWER COVER - LEFT HAND (Remove and Replace)

Correction code 1225010402 FRT 0.10 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  2. Disconnect the washer hose.
  3. Release the harness clip from the LH shock tower cover.
  4. Release the clips and remove the LH shock tower cover.

Install

  1. Secure the clips to install the LH shock tower cover.
  2. Install the harness clip to the LH shock tower cover.
  3. Connect the washer hose.
  4. Install the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).