2.0 - CONSOLE (Remove and Replace)
Correction code
1519020102
FRT
0.30
NOTE: Unless
otherwise explicitly stated in the procedure, the above correction code and
FRT reflect all of the work required to perform this procedure, including
the linked procedures. Do
not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are
created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make
sure wearing proper PPE when performing the below procedure.
Remove
- Remove the center console assembly. See 2.0 - CONSOLE (Remove and Install).
Install
- Install the center console assembly. See 2.0 - CONSOLE (Remove and Install).
- Locally connect a laptop with Toolbox 3 to the vehicle. See Toolbox 3 (Connect and Disconnect).
- Reinstall the vehicle firmware. See Software Reinstall - Touchscreen.
- In Toolbox 3.0, click the Actions tab, type "Actuator" into the search field, click TEST-SELF_VCUSB_X_HVAC-ACTUATORvia Toolbox: (link), click Run, and allow the routine to complete.
- Disconnect the laptop.
- Exit Service Mode. See Service Mode.
- Raise all windows and close all doors.