2026-05-13

Wiper Module - LHD (Remove and Replace)

Correction code 1750021202 FRT 0.30 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

  • 2026-05-13: Added pinch point warning.
Table 1. Torque Specifications: Wiper Module - LHD (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolts (x2) that attach the wiper module to the vehicle
9 Nm (6.6 lbs-ft)
  • 10 mm socket
Reuse

Remove

  1. Remove the cowl screen panel. See Cowl Screen (Remove and Replace).
  2. Remove the bolts (x2) that attach the wiper module to the body.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm socket
  3. Carefully pull the wiper module towards the front of the vehicle to release the rubber anchor from the bracket on the bulkhead.
  4. Rotate the wiper module, and then disconnect the electrical connector from the wiper module.
  5. Remove the wiper module from the vehicle.

Install

  1. With the wiper module facing upside down, connect the electrical connector. Then, rotate the wiper module towards the rear of the vehicle to ensure proper harness clearance.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    Warning
    Keep your fingers away from any potential pinch points and moving parts while connecting and installing the wiper module. Do not attempt to test the module until it is fully installed in the vehicle.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Check the harness to make sure it is routed correctly.
  2. Carefully push the wiper module towards the rear of the vehicle so that the rubber anchor inserts into the bracket on the bulkhead.
  3. Install the bolts (x2) that attach the wiper module to the body.
    9 Nm (6.6 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm socket
  4. Install the cowl screen panel. See Cowl Screen (Remove and Replace).
  5. Enable Service Mode through the touchscreen. See Service Mode.
  6. Unlock Gateway. See Gateway (Unlock).
  7. Run the Wiper Replacement procedure: on the touch screen, touch Closures > Closures > Windows > Wiper Module replacement, touch Run, and allow the routine to complete.
  8. Perform a software reinstall. See Software Reinstall - Touchscreen.
  9. Exit Service Mode through the touchscreen. See Service Mode.
  10. Raise LH front window and close LH front door.