Trim - A-Pillar - Lower - LH (Remove and Replace)
Correction code
1518010302
FRT
0.06
NOTE: Unless
otherwise explicitly stated in the procedure, the correction code and FRT
listed above reflect all of the work required to perform this procedure,
including the linked procedures. Do not stack correction
codes unless explicitly told to do so.
NOTE: See Flat Rate Times
to learn more about FRTs and how they are created.
NOTE: See Personal Protection
to make sure you are wearing proper PPE when performing the procedure
below.
NOTE:
See Ergonomic Precautions for
safe and healthy working practices.
Remove
- Remove the LH instrument panel end cap. See Instrument Panel - End Cap - Substrate - LH (Remove and Replace).
-
Release the topmost clip on the LH
A-pillar lower trim.
-
Pull the rearmost part of the LH
A-pillar lower trim upward to release the clips and tabs, and then pull the entire trim
rearward to remove the trim from the vehicle.
Install
-
Install the clips and tabs that attach
the LH A-pillar lower assembly to vehicle.
-
Install the topmost clip on the LH
A-pillar lower trim.
- Install the LH instrument panel end cap. See Instrument Panel - End Cap - Substrate - LH (Remove and Replace).