2024-11-11

Speaker - Front Door (Remove and Replace)

Correction code 2121010602 FRT 0.2 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: Speaker - Front Door (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Lower left bolt that attaches the front door speaker to the door
4.5 Nm (3.3 lbs-ft)
  • 8 mm socket
Reuse
Bolts (x3) that attach the front door speaker to the door
3.5 Nm (2.6 lbs-ft)
  • Torx T20 socket
Reuse

Remove

  1. Remove the LH front door trim panel. See Panel - Door Trim - Front - LH (LHD) (Remove and Replace).
  2. Disconnect the electrical connector from the front door speaker.
  3. Remove the lower left bolt that attaches the front door speaker to the door.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 8 mm socket
  4. Remove the remaining bolts (x3) that attach the front door speaker to the door, and then remove the speaker from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 socket

Install

  1. Position the front door speaker to the vehicle, and then install the bolts (x3) that attach the front door speaker to the door.
    3.5 Nm (2.6 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 socket
  2. Install the lower left bolt that attaches the front door speaker to the door.
    4.5 Nm (3.3 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 8 mm socket
  3. Connect the electrical connector to the front door speaker.
  4. Install the LH front door trim panel. See Panel - Door Trim - Front - LH (LHD) (Remove and Replace).