LIFTGATE LOWER TRIM - REAR SPEAKER (Remove and Replace)
Correction code
1511010302
FRT
0.10
NOTE: Unless
otherwise explicitly stated in the procedure, the above correction code and
FRT reflect all of the work required to perform this procedure, including
the linked procedures. Do
not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are
created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make
sure wearing proper PPE when performing the below procedure.
Remove
- Remove the liftgate upper trim. See LIFTGATE UPPER TRIM (Remove and Replace).
-
Release the clips and tabs, and then
remove the liftgate lower trim.
NoteWhen removing the last clip, hold the trim with one hand to prevent it from suddenly falling and damaging the connector.
- Disconnect the liftgate trim connector.
Install
- Connect the liftgate trim connector.
- Check the clips and replace any damaged clips.
- Align the locating pins to the hole and secure the clips and tabs to install the liftgate lower trim.
- Install the liftgate upper trim. See LIFTGATE UPPER TRIM (Remove and Replace).