2025-03-12

LIFTGATE POWER STRUT - LEFT HAND (Remove and Replace)

Correction code 1133050702 FRT 0.10 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

  • 1080562-00-A - TELESCOPING HOOD PROP

Remove

  1. Open the liftgate and support it with a telescoping hood prop.
  2. Remove the rear headliner panel. See REAR HEADLINER (Remove and Replace).
  3. Carefully lower the LH rear section of the headliner assembly to access the power strut connector.
  4. Disconnect the power strut connector from the body harness.
  5. Release the LH rear power strut harness grommet from the body.
  6. Release the LH upper power strut clip from the liftgate side ball stud, and lay the power strut down on the door jamb.
  7. Release the power strut clip from the body side ball stud.

Install

  1. Install the power strut clip to the body side ball stud.
    Informational PurposesAn informational icon, calling your attention
    Note
    Ensure that the spring clip is reset.
  2. Install the power strut clip to the liftgate side ball stud.
    Informational PurposesAn informational icon, calling your attention
    Note
    Ensure that the spring clip is reset.
  3. Remove the telescoping hood prop from the vehicle.
  4. Insert the power strut harness into the body and install the grommet.
  5. Connect the power strut harness connector.
  6. Install the LH rear portion of the headliner into position and clip it into place.
    Informational PurposesAn informational icon, calling your attention
    Note
    Seat the trunk seal to the edge of the trim.
  7. Install the rear headliner panel. See REAR HEADLINER (Remove and Replace).