2025-03-12

AUDIO SPEAKER TWEETER ACTIVE 25MM (Remove and Replace)

Correction code 2121010502 FRT 0.10 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: AUDIO SPEAKER TWEETER ACTIVE 25MM (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Screw that secures the blind spot indicator module assembly
1.5 Nm (1.1 lbs-ft)
  • Torx T20 bit
  • Digital Torque Screwdriver 0.10Nm - 2.0Nm
Reuse

Remove

  1. Remove the LH front tweeter. See Tweeter - Front Door - LH (Remove and Replace).
  2. Remove the screw and the tabs (x3) that secure the blind spot indicator module assembly.
    Informational PurposesAn informational icon, calling your attention
    Note
    Be careful not to damage the lamp pipe.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 bit
    • Digital Torque Screwdriver 0.10Nm - 2.0Nm
  3. Release the tabs (x3) to remove the 25mm tweeter speaker.

Install

  1. Engage the tabs (x3) to install the 25mm tweeter speaker.
  2. Install the screw and the tabs (x3) that secure the blind spot indicator module assembly.
    1.5 Nm (1.1 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 bit
    • Digital Torque Screwdriver 0.10Nm - 2.0Nm
  3. Install the LH front tweeter. See Tweeter - Front Door - LH (Remove and Replace).