2026-08-09

Audio Speakers - Audio Speaker Full Range 100MM - Center  (Remove and Replace)

Correction code 2121010402 FRT 0.42 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Remove

  1. Open both front doors and lower both front windows.
  2. Remove the LH and RH upper A-pillar trims. See Trim - A-Pillar - Upper - LH (Remove and Replace).
  3. Remove the wrap around assembly. See Speaker Grille - Instrument Panel (Remove and Install).
  4. Remove the center instrument panel speaker screws (x3).
    Tip
    Use of the following tool(s) is recommended:
    • SET, 1/2" CUT BIT. (78 PCS DOUBLE END MINI RATCHET)
    • Wiha Torque Screwdriver 0.8-5 Nm screwdriver (installation only)
  5. Release the speaker connector, and then remove the center instrument panel speaker.

Install

  1. Connect the center instrument panel speaker connector.
  2. Install the center instrument panel speaker screws (x3).
    2.3 Nm (1.7 lbs-ft)
    Tip
    Use of the following tool(s) is recommended:
    • SET, 1/2" CUT BIT. (78 PCS DOUBLE END MINI RATCHET)
    • Wiha Torque Screwdriver 0.8-5 Nm screwdriver (installation only)
  3. Install the wrap around assembly. See Speaker Grille - Instrument Panel (Remove and Install).
  4. Install the LH and RH upper A-pillar trims. See Trim - A-Pillar - Upper - LH (Remove and Replace).
  5. Raise both front windows and close both front doors.