2026-08-09

Bracket - Front License Plate - NA (Install)

Correction code 1207010401 FRT 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

  • 2026-02-13: Added Caution on operating temperature.
CAUTION
The 3M tape used to affix the license plate bracket to the front fascia requires an operating temperature of at least 16℃ (61°F). If the temperature of the front fascia and/or license plate bracket is below 16℃ (61°F), use a heat gun with caution to heat up the parts.

Procedure

  1. Use IPA wipes to clean the front fascia surface in preparation for installation of the front license plate bracket, and allow 1 minute to dry.
  2. Identify the top of the license plate bracket, and then dry fit the bracket to the vehicle.
    Note
    Align the guide point on the bracket with the fascia grill center line and the front fascia camera.
  3. Remove the adhesive backing of the 3M double-sided tape (x3), and then install the license plate bracket.