2025-03-14

License Plate - Rear (EMEA) (Install)

Correction code 1207010606 FRT 0.05 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

  • 2132211-00-A - Rear license plate bracket EMEA, 2025+ MY

Torque Specifications

Table 1. Torque Specifications: License Plate - Rear (EMEA) (Install)
Description Torque Value Recommended Tools Reuse/Replace Notes
License plate self-tapping screws (x2)
1 Nm (.7 lbs-ft)
  • Cordless Ratchet/Impact Driver
  • 8 mm socket
  • 2 in extension
  • Digital Torque Screwdriver 0.10Nm - 2.0Nm
Reuse

Procedure

  1. Install the license plate onto the license plate mounting bracket (2132211-00-A).
  2. Install the license plate mounting bracket to the rear fascia.
    Informational PurposesAn informational icon, calling your attention
    Note
    Place the tool at the center of the fascia. Make sure the notches align with the license plate lights and the tool is secured.
  3. Install the license plate self-tapping screws (x2).
    1 Nm (.7 lbs-ft)
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    To prevent damage to the bumper beam, do not use self tapping screws that are longer than 16mm.
    Informational PurposesAn informational icon, calling your attention
    Note
    After tapping, use low-torque setting to drive the screws.
    Informational PurposesAn informational icon, calling your attention
    Note
    Torque at later steps.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Cordless Ratchet/Impact Driver
    • 8 mm socket
    • 2 in extension
    • Digital Torque Screwdriver 0.10Nm - 2.0Nm
  4. Remove the license plate mounting bracket from the rear fascia.
  5. Torque the license plate screws (x2).
    1 Nm (.7 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Cordless Ratchet/Impact Driver
    • 8 mm socket
    • 2 in extension
    • Digital Torque Screwdriver 0.10Nm - 2.0Nm