USB Bezel - Center Console (Remove and Replace)
Correction code
1519010162
FRT
0.1
NOTE: Unless
otherwise explicitly stated in the procedure, the correction code and its
associated FRT reflect all of the work required to perform this procedure,
including the linked procedures. Do not stack correction
codes unless explicitly told to do so.
NOTE: See Flat Rate Times to
learn more about FRTs and how they are created.
NOTE: See Personal Protection to make
sure you are wearing proper PPE when performing the procedure below.
NOTE: See Ergonomic Precautions for safe and healthy
working practices.
Remove
- Remove the rear end panel. See Console - End Panel (Remove and Replace).
-
Use a plastic trim tool to release the
clips and tabs that attach the USB bezel to the vent cover panel.
-
Disconnect the USB connector, and then
remove the USB bezel from the center console.
Install
-
Connect the USB connector.
-
Install the clips and tabs that attach
the USB bezel to the vent cover panel.
- Install the rear end panel. See Console - End Panel (Remove and Replace).