2025-03-12

Height Adjuster - Seatbelt - 1st Row - LH (Remove and Replace)

Correction code 2005010302 FRT 0.30 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Torque Specifications

Table 1. Torque Specifications: Height Adjuster - Seatbelt - 1st Row - LH (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolt that attaches the upper D-ring to the adjustable top loop
30 Nm (22.1 lbs-ft)
  • Torx T50 socket
 Replace 1786770-00-A
Bolt that attaches the LH height adjuster to the body
20 Nm (14.7 lbs-ft)
  • Torx T40 socket
 Replace 1845880-00-B

Remove

  1. Remove the upper B-pillar trim. See Trim - B-Pillar - Upper - LH (Remove and Replace).
  2. Remove and discard the bolt that attaches the upper D-ring to the adjustable top loop.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T50 socket
  3. Remove and discard the bolt that attaches the LH height adjuster to the body.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T40 socket
  4. Remove the adjustable top loop.

Install

  1. Install the adjustable top loop.
  2. Install a new bolt (1845880-00-B) to attach the LH height adjuster to the body.
    20 Nm (14.7 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T40 socket
  3. Install a new bolt (1786770-00-A) to attach the upper D-ring to the adjustable top loop.
    30 Nm (22.1 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T50 socket
  4. Install the upper B-pillar trim. See Trim - B-Pillar - Upper - LH (Remove and Replace).