23/07/2024 17:26:35

Car Computer - Drip Guard (Remove and Install)

Correction code 2110022011 2110022012 FRT 0.30 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Open the front doors and lower the front windows.
  2. Remove the LH mid A-pillar trim. See A-B-C Post Interior Trim - A-Pillar Mid Trim - LH (Remove and Install).
  3. Remove the LH lower A-pillar trim. See A-B-C Post Interior Trim - A-Pillar Lower Trim - LH (Remove and Install)
  4. Remove the footwell cover. See Dash Support Frame - Footwell Cover (Remove and Install).
  5. Repeat steps 2 and 3 for the RH side of the vehicle.
  6. Remove the rear underhood apron. See Underhood Trim - Rear Apron Assembly (Remove and Install).
  7. Disconnect MV power. See Disconnect MV Power.
  8. Remove the mid instrument panel assembly. See Dash Panel - IP Mid Panel Assembly (Remove and Install).
  9. Remove the lower IP assembly. See Dash Panel - Instrument Panel Lower Assembly (Remove and Install).
  10. Remove the glovebox assembly. See Dash Panel - IP Glovebox Assembly (Remove and Install).
  11. Release the clips (x2) that attach the car computer drip guard to the vehicle, and then remove the drip guard from the vehicle.

Install

  1. Position the car computer drip guard into the vehicle, and then install the clips (x2) that attach the drip guard to the vehicle.
  2. Install the glovebox assembly. See Dash Panel - IP Glovebox Assembly (Remove and Install).
  3. Install the lower IP assembly. See Dash Panel - Instrument Panel Lower Assembly (Remove and Install).
  4. Install the mid instrument panel assembly. See Dash Panel - IP Mid Panel Assembly (Remove and Install).
  5. Reconnect MV power. See Disconnect MV Power.
  6. Install the rear underhood apron. See Underhood Trim - Rear Apron Assembly (Remove and Install).
  7. Install the RH lower A-pillar trim. See A-B-C Post Interior Trim - A-Pillar Lower Trim - LH (Remove and Install)
  8. Install the RH mid A-pillar trim. See A-B-C Post Interior Trim - A-Pillar Mid Trim - LH (Remove and Install).
  9. Install the footwell cover. See Dash Support Frame - Footwell Cover (Remove and Install).
  10. Repeat steps 7 and 8 for the LH side of the vehicle.
  11. Raise the front windows and close the front doors.