2024-07-23

Cover - Crossmember Riser - 1st Row Seat - LH (Remove and Install)

Correction code 1301061061 1301061062 FRT 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.

Remove

  1. Open the LH front door and lower the LH front window.
  2. Move the LH front seat fully rearward.
  3. Remove the LH front floor mat.
  4. Open the RH front door and lower the RH front window.
  5. Release the clips (x4) that attach the LH front seat riser crossmember cover to the seat assembly, disconnect the electrical connector, and then unfold the cover to remove to remove it from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Remove the cover from 2nd row area.

Install

  1. Position the LH front seat riser crossmember cover into the vehicle through the 2nd row area, connect the electrical connector, and then fold the cover around the crossmember to secure the clips (x4) that attach the cover to the vehicle.
  2. Raise the LH rear window and close the LH rear door.
  3. Install the LH front floor mat.
  4. Restore the LH front seat back to its original position.
  5. Raise the LH rear window and close the LH rear door.