2024-07-23

Maplight - Front (Remove and Install)

Correction code 1520068011 1520068012 FRT 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.

Remove

  1. Remove the front header trim. See Trim - Header - Front (Remove and Install).
  2. Release the clips (x12) and datums (x2) that attach the front maplight to the front header trim, and then remove the maplight from the header trim.

Install

  1. Position the front maplight to the front header trim, and then secure the clips (x12) and datums (x2) that attach the maplight to the header trim.
  2. Install the front header trim. See Trim - Header - Front (Remove and Install).